Korg drumlogue Owner's Manual page 36

USER
SOUND SELECT
SELECT
Select the user synth to load.
At the time of shipment from the factory, the user synth "Nano" developed in col-
laboration with Sinevibes is installed on this unit.
Parameters vary depending on the user synth. For explanations about
TIP
functions other than nano, refer to the manual for each user synth.
PARAMETERS * For Nano
NOTE
Sets the sound pitch.
WAVE
Select the waveforms of two oscillators.
DETUNE
Adjusts the pitch shift between the main oscillator and the sub oscillator.
BALANCE
Adjusts the volume balance between the two oscillators.
FILTER
Select the filter type. There are three types of filters: low pass, high pass, and band pass.
CUTOFF
Adjusts the cutoff frequency of the filter.
KEYTRACK
Adjusts the key tracking effect on the filter cutoff.
RESON (RESONANCE)
Adjusts the cutoff resonance of the filter.
EG TYPE
Select the type of EG (Envelope Generator).
D: Type with the fixed attack and adjustable decay only
A1D: Adjusts the attack and decay at the same time. The attack time and decay
time are the same.
A2D: Adjusts the attack and decay at the same time. The decay time is twice the
length of the attack time.
[---, Nano, ...]
[C-1...C5]
[2x Saw, 2x Sqr, 2x Tri, Saw+Sqr, Saw+Tri, Sqr+Tri, Ring 1..3]
[-24.0...+24.0]
[0%...100%]
[LP, HP, BP]
[0%...100%]
[0%...100%]
[0%...100%]
[D, A1D, A2D]
36