Korg drumlogue Owner's Manual page 29

SOUND SELECT
LAYER
Select the layer sound type of low tom or high tom.
A short PCM sample is layered on the low tom and high tom analog sound sourc-
es, allowing you to change the tone character of the attack.
PARAMETERS
SWEEP
Adjusts the level of the sweep (which changes the pitch when triggered) of low
tom or high tom.
ATTACK
Adjusts the level of the layered sound of low tom or high tom.
CUTOFF
Sets the cutoff frequency of the filter of low tom or high tom.
You can select the low-pass filter, no filter (THRU), or the high-pass filter.
RESON (CUTOFF RESONANCE) [0.0%...100.0%]
Sets the cutoff resonance of the filter of low tom or high tom.
If you increase the value, the filter oscillates, which may cause the sound to
continue.
DRIVE
Sets the distortion amount of low tom or high tom. A fat sound is created by mod-
erately distorting low tom or high tom.
MIX/ROUTE
PAN
Adjusts the pan pot (left and right stereo localization).
DELAY
Adjusts the feed amount of the delay effect.
REVERB
Adjusts the feed amount of the reverb effect.
MASTER
Sets the master effect to On or Bypass.
SIDECH (SIDECHAIN)
Adjusts the feed amount of the SIDECHAIN pass.
[01..10]
[0.0%...100.0%]
[0.0%...100.0%]
[L0.0%...L99.5%, THRU, H0.5%...H100.0%]
[OFF, LOW, HIGH]
[L100%...L1%, C, R1%...R100%]
[0.0%...100.0%]
[0.0%...100.0%]
[ON, BYPASS]
[0.0%...100.0%]
29