Korg drumlogue Owner's Manual page 42

RELEASE
Adjusts the release time of the compressor.
RATIO
Adjusts the compression ratio of the compressor.
MAKEUP
You can increase the overall gain of the signal to compensate for compression.
KNEE
Adjusts the smoothness at the beginning of the compressor effect.
SIDECH (SIDECHAIN)
If you want to enable the input signal from SIDECHAIN, set this parameter to ON.
WET
Adjusts the ratio of effect sounds. The greater the value, the more the signal is compressed.
PARAMETERS - For Filter
MODE
Select Filter mode.
There are six types in total, two types each for low pass, band pass, and high pass.
SATURATE
Adjusts the saturation amount of the filter.
RESON (RESONANCE)
Adjusts the resonance of the filter.
CUTOFF
Adjusts the cutoff frequency of the filter.
PARAMETERS - For Boost
CENTER
Adjusts the center frequency you want to boost.
WIDTH
Adjusts the frequency bandwidth from the center frequency you want to boost.
SATURATE
Adjusts the saturation amount of the booster.
[50ms...1s]
[1...10]
[0.00dB...8.00dB]
[0.00dB...8.00dB]
[OFF, ON]
[0.0%...100.0%]
[THRU, LPF 2, LPF 4, BPF 2, BPF 4, HPF 2, HPF 4]
[0.0%...100.0%]
[0.0%...100.0%]
[0.0%...100.0%]
[0.0%...100.0%]
[0.0%...100.0%]
[0.0%...100.0%]
42