Connecting The Ethernet Communication Cables - Agilent Technologies 1100 Series User Manual

Connecting the Ethernet Communication Cables

Thermo Scientific
To connect the Ethernet communication cable to an Agilent 1100 Series LC
1. Connect a category 5, shielded Ethernet cable from the JetDirect 400N network card to
the Ethernet switch.
CAUTION To comply with safety and EMC regulations, you must use category 5,
shielded Ethernet cables to make the Ethernet connections for your instrument.
2. Connect a category 5, shielded Ethernet cable from the Ethernet switch to the Ethernet
card in the computer dedicated to the LC system (typically network interface card
number 3).
Figure 3. Ethernet connections
Computer
Optiplex GX520
(subject to change)
USB
ENET
Ethernet Switch
Agilent 1100 Series LC Devices Connecting the Hardware and Triggering Data Acquisition
Connecting the Ethernet Communication Cables
JetDirect 400N card
(installed in one of
the Agilent modules)
Not drawn to scale
Cat5 shielded
Ethernet cables
2
Connecting the Hardware
7