Exiting Maintenance Mode; Function Code 0: Maintenance Mode; Function Code 1: Run Drive Diagnostics - IBM TS3310 Maintenance Information

Exiting Maintenance Mode

The drive must be in Function Code
To exit Maintenance Mode:
1. Press the Unload Button once per second until
2. Press and hold the Unload Button for three or more seconds, then release it.
To exit Maintenance Mode when an error is displayed:
1. Press the Unload Button three times within two seconds to clear the error code
2. Press and hold the Unload Button for three or more seconds, then release it.
Note: The drive will exit Maintenance Mode automatically when:

Function Code 0: Maintenance Mode

Function Code
maintenance functions, or exiting from Maintenance Mode.
1. Place the drive in Maintenance Mode. For instructions, see"Entering
2. To exit Maintenance Mode, see "Exiting Maintenance Mode."
The drive exits Maintenance Mode automatically after it completes a maintenance
function or after 10 minutes if no action has occurred.

Function Code 1: Run Drive Diagnostics

Approximate Run Time = 20 minutes per loop
Total Number of Loops = 10
Function Code
and unload cartridges and read and write data.
Press the Unload Button to stop the diagnostic and exit maintenance mode.
Pressing the Unload Button once will abort the test at the end of the current test
loop. Pressing the Unload Button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
D-28
TS3310 Tape Library Maintenance Information
cycle past the desired code, press the Unload Button once per second util the
code appears.)
and return to Function Code
v it completes a maintenance function
v if there is an error code for anything other than a hardware problem
v if no action has occurred for 10 minutes
The drive will not exit Maintenance Mode automatically if there is an error
code displayed that indicates there is a hardware problem.
0
makes the drive available for running drive diagnostics or
Maintenance Mode" on page D-27.
1
runs tests that determine whether the drive can properly load
0
in order to exit Maintenance Mode.
0
appears in the SCD. (If you
0
.