Internal Components - IBM TS3310 Maintenance Information

Reinstalling/Replacing a Power Supply
1. Grasp the power supply handle ( 1 in Figure 8-54 on page 8-53) while
2. Tighten the two thumb screws ( 2 in Figure 8-54 on page 8-53) on the power
3. Connect the power supply by plugging in each end of the power cord in the
4. Toggle the power switch ( 4 in Figure 8-54 on page 8-53) on the power supply
5. If there is no redundant power supply, power ON the library using the power
Removing a Redundant Power Supply
1. Locate the slot for the redundant power supply to be removed on the back of
2. Toggle the redundant power supply power switch ( 4 in Figure 8-54 on page
3. Unplug the power cord from the redundant power supply receptacle ( 3 in
4. Loosen the two thumb screws ( 2 in Figure 8-54 on page 8-53) by turning
5. Grasp the handle ( 1 in Figure 8-54 on page 8-53) and pull the power supply
6. Install a metal cover plate over the vacant redundant power supply slot if you
Replacing a Redundant Power Supply
1. Locate the slot for the redundant power supply on the back of the library
2. Remove the cover plate over the vacant redundant power supply slot, if
3. Insert the redundant power supply by gripping the handle ( 1 in Figure 8-54
4. Tighten the two thumb screws ( 2 in Figure 8-54 on page 8-53) that hold the
5. Connect the power cord to the power supply ( 3 in Figure 8-54 on page 8-53)
6. Turn ON power to the redundant power supply, using the switch ( 4 in

Internal Components

The library has the following internal components:
v Y-axis/Picker Assembly
v Picker Assembly
v Y Motor Assembly
v M2 Robot Assembly
v M2 Picker Assembly
8-54
TS3310 Tape Library Maintenance Information
supporting it from underneath. Then, line up the power supply with the guides
in the slot, and carefully push the power supply into the library.
supply by turning them clockwise.
proper sequence.
Attention: First, connect the power cord to the power supply component ( 3
in Figure 8-54 on page 8-53). Then, connect the power cord to the power source.
to the | (ON) position.
button on the front of the machine.
the library.
8-53) to the O (OFF) position.
Figure 8-54 on page 8-53).
them counterclockwise.
toward you. Support the component from underneath with your other hand.
are not immediately installing a replacement.
module.
necessary.
on page 8-53), sliding it into the guide slots, and pushing it into the empty slot.
redundant power supply in place.
and to its source.
Figure 8-54 on page 8-53) on the power supply.