Required Tools; Electrostatic Discharge; Servicing Library Components: Library State Required - IBM TS3310 Maintenance Information

For information on powering the library ON/OFF or taking the library
ONLINE/OFFLINE, see:
v "Taking the Drives/Library Online/Offline" on page 7-38
v "Shutting Down/Restarting the Library" on page 7-39

Required Tools

Servicing the library requires the following tools:
v T10 TORX screwdriver with a static safe handle
v #1 and #2 Philips screwdrivers
v small flat blade screwdriver
v Electrostatic Discharge (ESD) Kit (P/N 93F2649)
v safety glasses

Electrostatic Discharge

Important: A discharge of static electricity can damage static-sensitive devices or
To prevent electrostatic damage, observe the following precautions:
v Transport products in static-safe containers such as conductive tubes, bags, or
v Keep electrostatic-sensitive parts in their containers until they arrive at static-free
v Cover the unit with approved static-dissipating material. If available, provide a
v Keep the work area free of non-conducting materials, such as ordinary plastic
v Make sure you are always properly grounded when touching a static-sensitive
Table 8-2. Servicing library components: Library state required (continued)
Part
I/O Station safety flap
LCB/CF
Operator panel
Picker assembly
Power switch/LED board
Power supply, primary
Power supply, redundant
Storage column
Tape drive sled
Y-axis assembly
Y motor
microcircuitry. Proper packaging and grounding techniques are
necessary precautions to prevent damage.
boxes.
stations.
ground strap connected to the work surface and properly grounded tools and
equipment. If a ground strap is not available, touch a metal surface to discharge
any static electricity in your body.
assembly aids and foam packing.
component or assembly.
Required Library Status
Power OFF
Power OFF
Power OFF
Power OFF
Power OFF
Power OFF
Power ON/Normal
Power OFF
Power ON
Power OFF
Power OFF
Chapter 8. Add, Check, Adjust, Remove, and Replace Procedures
8-3