Media Supply Positions - Intermec EasyCoder F2 User Manual

Media Compartment, cont.

Media Supply Positions

Intermec EasyCoder F2 – User's Guide
There are four sets of threaded holes and slots in the printer's
center section for the media supply roll post or rotating hub
(optional). These slots allow the largest possible roll size to fi t,
given the limitations of any liner takeup and/or the full enclosure
provided by the long side door. The positions are indicated by
numbers engraved in the center section.
• Position 1 is used when the media compartment is fully
enclosed by a long side door, regardless of the existence of
any integral liner takeup unit. Maximum roll size is 152 mm
(6 inches).
• Position 2 is used when the printer has a short side door
that only encloses the print mechanism, but does not have
an integral liner takeup unit. Maximum roll size is 213 mm
(8.38 inches).
• Position 3 is used when the printer has a short side door and
an integral liner takeup unit. Maximum roll size is 213 mm
(8.38 inches).
• Position 4 is reserved for future development.
The printer can also use an external media supply located behind
the printer.
Chapter 2 Installation
Pos. 3
Pos. 1
Pos. 2
Pos. 4 (not used)
13