Intermec Shell Diagram - Intermec EasyCoder F2 User Manual

Chapter 8 Intermec Shell Startup Program
Intermec Shell v4.8 Diagram
POWER ON
ENTER=SHELL
5 sec. v.4.8
ENTER=SHELL
4 sec. v.4.8
ENTER=SHELL
3 sec. v.4.8
ENTER=SHELL
2 sec. v.4.8
ENTER=SHELL
1 sec. v.4.8
Last selected
application is started
Default:
Fingerprint 7.61 w. std I/O = "uart1:"
Legend:
Return to previous menu.
Proceed to next menu.
Accept displayed option
and proceed, or
execute displayed option.
Perform a Testfeed
anywhere in Intermec Shell.
Enter the Setup Mode
from anywhere
in Intermec Shell.
Enter Terminal Setup
by transmitting T T T
or t t t to printer,
in menus marked with a
shade of gray!
64
SHELL
SEL. APPLICATION
The Windows Driver
option is not used
with EasyCoder
F-series printers
SHELL
SETUP
SHELL
PRINT SETUP
SHELL
TESTFEED
SHELL
TEST LABEL
SHELL
DEFAULT SETUP
SHELL
SOFTWARE UPDATE
SHELL
REBOOT
Restarts the printer (same as power off/on)
SEL. APPLICATION
CURRENT APPL.
SEL. APPLICATION
LABELSHOP
SEL. APPLICATION
WINDOWS DRIVER
SEL. APPLICATION
Fingerprint 7.61
SEL. APPLICATION
Direct Protocol
SEL.APPL rom:
LINE_AXP.PRG
SETUP:
See the chapter "Setup Mode"
SER-COM,UART1
Prints a list of current setup values (test label #5).
Performs a Testfeed (feeds out a number of blank copies
while autoadjusting the label stop sensor.)
Prints test labels #1-4 in a loop.
Press Enter for each new label.
ARE YOU SURE ? DEFAULT SETUP
Y=ENTER/ N=F5 PERFORMED
UPDATE: PC-CARD ERASE
PC-CARD?
UPDATE: TRANSFER FILE
FIRMWARE USING ZMODEM
Intermec EasyCoder F2 – User's Guide
Last selected application is started
Note: Dotted channels are only shown if
the corresponding optional interface pcb
is fitted.
STD I/O CHANNEL
auto
STD I/O CHANNEL
UART1
STD I/O CHANNEL
UART2
STD I/O CHANNEL
UART3
STD I/O CHANNEL
CENTRONICS
STD I/O CHANNEL
net1:
STD I/O CHANNEL
usb1:
TRANSFER FILE
USING ZMODEM
PROGRAMMING
PC-CARD
PROGRAMMING
COMPLETED
Printer rebooted
automatically.