Tickets With Gap - Intermec EasyCoder F2 User Manual

Appendix 2 Media Specifi cations
Media, cont.

Tickets with Gap

a
b
c
f
d
e
TICKETS & TAGS
FEED
DIRECTION
96
⇐ a ⇒ Media Width:
Maximum:
Minimum (standard):
Minimum (Quick-Load):
⇐ b ⇒ Copy Length:
Max. length between slots:
Min. length between slots:
Under ideal circumstances, a minimum ticket length of 4 mm (0.16
inches) could be used. It requires the sum of the copy length (b) and
the detection slit height (e) to be larger than 7 mm (0.28 inches),
that batch printing is used, and that no pull back of the media is
performed. Intermec does not guarantee that such short tickets will
work, but it is up to the user to test this in his unique application.
⇐ c ⇒ LSS Detection Position:
Five fi xed positions (distance from inner edge of the media):
3 mm (0.118 inches)
8 mm (0.315 inches)
12 mm (0.472 inches)
16 mm (0.639 inches)
20 mm (0.787 inches)
⇐ d ⇒ Detection Slit Length:
The length of the detection slit (excluding corner radii) must
be minimum 2.5 mm (0.10 inches) on either side of the LSS
detection position (e).
⇐ e ⇒ Detection Slit Height:
Maximum:
Recommended:
Minimum:
Media Type Setup:
• Ticket (w gaps)
Do not allow any perforation to break the edge of the media as this
may cause the media to split and jam the printer.
60.0 mm
25.0 mm
40.0 mm
depends on DRAM size
8.0 mm
21.3 mm
1.6 mm
1.2 mm
Intermec EasyCoder F2 – User's Guide
(2.36 inches)
(1.00 inches)
(1.57 inches)
(0.32 inches)
(0.83 inches)
(0.06 inches)
(0.05 inches)