Usb Interface - Intermec EasyCoder F2 User Manual

Appendix 3 Interfaces

USB Interface

USB = Universal Serial Bus
100
To use the USB interface for printing from a PC, you need a
special Intermec USB printer driver installed in your PC.
The EasyCoder F2 is a so called "self-powered device." We
recommend that you only connect one EasyCoder F2 to each
USB port on the host, either directly or via a hub. Other devices,
like a keyboard and a mouse, can be connected to the same hub.
If you need to connect more than one Intermec USB printer to a
host, you should use different USB ports.
Using a USB Class A/B cable, connect the Class A plug to your
PC or hub and the Class B plug to your EasyCoder F2 printer.
The USB interface is essentially a one-way communication inter-
face and is thus not recommended for programming. There is no
communication setup for the USB port.
USB
Connect to USB receptacle on the printer's rear plate.
The USB interface requires Intermec Fingerprint v7.50 or later.
USB Class A connector.
Connect to PC or hub.
USB Class B connector.
Note:
Intermec EasyCoder F2 – User's Guide