Intermec Shell Startup Program Introduction - Intermec EasyCoder F2 User Manual

Chapter 8
Intermec Shell Startup Program
Introduction
60
Intermec Shell is a startup program (also called "autoexec-fi le"),
which is a program that automatically starts running when the
printer is switched on. Intermec Shell helps the operator to
choose between a number of standard or custom-made applica-
tion programs and to start certain useful facilities, as listed below.
Application Programs
• Intermec LabelShop
• Intermec Windows Driver
• Intermec Fingerprint
• Intermec Direct Protocol
• LINE_AXP .PRG
• Other application programs in the printer's memory
A prerequisite is that the program is provided with the extension
".PRG". However, some original Intermec utility programs are
excluded as long as they remain stored in "rom:":
- ERRHAND.PRG
- FILELIST.PRG
- LBLSHTXT.PRG
- MKAUTO.PRG
- SHELLXP .PRG
- WINXP .PRG
Other Facilities
• Setup Mode
• Print Setup
• Testfeed
• Test Label
• Default setup
• Update PC card
• Reboot
Intermec Shell is factory-installed in the printer's permanent
memory (device "rom:"). If you insert a memory card with another
startup fi le before you switch on the printer, or if there is a startup
fi le stored in the printer's permanent memory (device "c:"), this
startup fi le will be used instead of Intermec Shell (see Chapter 3,
"Startup Files").
(WYSIWYG label design program)
(do not use)
(for creating your own programs or to
run the Intermec InterDriver)
(easy-to-use slave protocol)
(line analyzer program)
(manual setup from printer's keyboard)
(printing setup on label)
(formfeeds + auto-adjust of the LSS)
(printing of test labels)
(resetting all setup parameters to default)
(downloading data from a host to a PC
card in the printer, or upgrading the
printer's fi rmware from a PC card)
(restarting the printer)
Intermec EasyCoder F2 – User's Guide
.
.