Setting Preambles And Postambles - Intermec Trakker Antares 2410 System Manual

Appendix D—Using Default and Optional Applications
Syntax: Preamble A
Bar Codes: To set the preamble or postamble using the AA, AB, or AC configuration
308
4 Scan this bar code:
Exit Accumulate Mode
*/M/O*
*-/*

Setting Preambles and Postambles

With the EM9560.BIN application, you can set Preamble A, Preamble B,
and Postamble C on the terminal and make it compatible with the 95XXs.
The preambles are prepended and the postamble is appended to the data
that is transmitted through all the serial ports.
Preamble A, Preamble B, and Postamble C can each be up to 25 ASCII
characters in length. If you enter a preamble or postamble command
without entering data, the preamble or postamble buffer is cleared.
AAdata or +.data
Preamble B ABdata or ++data
Postamble C ACdata or +%data
Note: To set this command using bar code labels, you must also use the
bar code labels in Appendix B. To use these labels, you must configure the
terminal to use Code 39 in Full ASCII mode. For help, see "Full ASCII
Mode for Code 39" on page 309.
commands:
1 Scan one of these bar code labels:
Enter Accumulate Mode /
Set Preamble A
*+/$+AA*
*+/$+AA*
Enter Accumulate Mode / Set Postamble C
*+/$+AC*
*+/$+AC*
2 Scan a value for data from the "Full ASCII Bar Code Chart" on page
284. The preamble or postamble can be from 1 to 25 characters.
3 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
4 Repeat Steps 1 to 3 to set another preamble or postamble.
39 AGaramond
nugget
Enter Accumulate Mode /
Set Preamble B
*+/$+AB*
*+/$+AB*
Trakker Antares 2400 Family System Manual