Power Saver - Icom IC-T2H Instruction Manual

D Auto power OFF
This item allows you to set a time at
which the transceiver will automati-
cally turn OFF. The power OFF time
can be set to 20, 40, 60 min. or turned
off.
D LCD backlighting
When set to AUTO, display backlight-
ing automatically turns on when a key
is pushed; when set to OFF display
backlighting cannot be turned ON;
when set to ON display backlighting
remains ON continuously.
D Beep tones ON/OFF
Confirmation beep tones normally
sound when you push a key or switch.
These can be turned ON or OFF as
you prefer.
• When [BEEP] is assigned to one of the
keys (see p. 29), push this key to toggle
beep tones on/off without using initial set
mode.
D Auto repeater
D Power saver
This item sets the power saver duty
cycle—the ratio of receive circuit on to
receive circuit off while standing by.
The duty cycle can be set to auto-
matic, 1:4 or OFF. Setting to auto-
matic conserves the most battery
power.
AUTO
1:4
OFF
MR
D DTMF speed
D LCD contrast
This item sets the function display
contrast to one of two levels—"1" is
low contrast and "2" is high contrast.
OTHER FUNCTIONS
(U.S.A version only, see p. 17)
Selects "1:4" duty ratio when receiving no signal
for 5 sec., then "1:8" 60 sec. after that.
Standby : 125 msec.
Circuit idle : 500 msec.
No power saver function.
(see p. 23)
10
29