Ani Operation - Icom IC-T2H Instruction Manual

D Calling group stations
➀
Turn power on, then select the desired group channel.
➁
Enter the 3-digit ANI code including the group code "D"—
the transceiver calls the desired station automatically.
• The transceiver transmits the pre-programmed selective code.
• When entering a 3-digit code, the transceiver automatically trans-
mits a group code after the 3rd digit is entered.
• When making group calls the transceiver does not ring and no
answer back connection code is received.
• You can make an announcement to your group immediately with-
out a connection procedure.
➂
Push [PTT] in the regular way to communicate.
➃
When your conversation is finished, while pushing [PTT],
push [#] to transmit a disconnect code.
D Group call code examples
[Example 1]
If "11D" is transmitted, transceivers with receive codes "110"
to "119" are called.
[Example 2]
If "1D3" is transmitted, transceivers with receive codes "103,"
"113,"..."183" and "193" are called.
NOTE: "DDD" transmits to all transceivers.
D Waiting for a call
➀
Turn power on, then select the de-
sired channel.
• The transceiver may be programmed
to start a scan at power on.
➁
When you receive a selective call,
the transceiver "rings."
• Push [ANI CODE] to display the re-
ceive code.
➂
Push [PTT] to send a connection code within 10 sec.
➃
While " " flashes, converse with the connected station.
➄
When your conversation is finished, you may receive a dis-
connect code.
• Transmitting a disconnect code from your side (push [PTT] + [#])
is also possible (except for group call receive).
• " " stops flashing.
11

ANI OPERATION

35