Dial Select Step; Beep Tones; Power Saver - Icom IC-Q7A Instruction Manual

Dial select step

This transceiver has a 1 MHz tuning step for quick frequency
setting. This dial select step can be set to 100 kHz, 1 MHz or
10 MHz steps, as desired.
D Setting dial select step
q Select VFO mode with [V/M].
w Push [V/M] for 2 sec. to enter set mode.
e Rotate [DIAL] until "D SEL" appears.
• "D SEL" disappears after 1 sec. and "dS" appears.
r While pushing [FUNC], rotate [DIAL] to select the desired
dial select step.
• 100 kHz, 1 MHz and 10 MHz steps can be selected.
t Push [V/M] to exit set mode.
100 kHz step 1 MHz step

Beep tones

The confirmation beep tones, which sound each time a switch
is pushed, can be turned ON or OFF, as desired.
q Push [V/M] for 2 sec. to enter set mode.
w Rotate [DIAL] until "BEEP" appears.
• "BEEP" disappears after 1 sec. and "bE" appears.
e While pushing [FUNC], rotate [DIAL] to turn the confirma-
tion beep ON or OFF.
r Push [V/M] to exit set mode.

Power saver

The power saver function reduces the current drain to con-
serve battery power.
q Push [V/M] for 2 sec. to enter expanded set mode.
w Rotate [DIAL] until "P SAVE" appears.
10 MHz step
• Turn the expanded set mode ON for selection. (p. 28)
• "P SAVE" disappears after 1 sec. and "PS" appears.
e While pushing [FUNC], rotate [DIAL] to turn the power
saver ON (AUTO) or OFF.
r Push [V/M] to exit set mode.
For packet operation, the power saver should be turned
OFF to receive reliable packet data.
10
OTHER FUNCTIONS
29