Other Functions; I Initial Set Mode - Icom IC-T2H Instruction Manual

10

OTHER FUNCTIONS

I Initial set mode

Initial set mode is accessed at power on and allows you to
set seldom-changed settings. In this way you can "customize"
transceiver operations to suit your preferences and operating
style.
D Entering initial set mode
➀
While pushing [8] + [0], rotate [PWR] to turn power on.
• The transceiver enters initial set mode and "mS SImP" or "mS
noRm" (see right) is displayed.
➁
Push [t] one or more times to select the desired display
as described on the following pages.
➂
Push [Y]/[Z] to select the desired condition.
➃
Turn power off, then on again to exit initial set mode and
select the previous operating mode.
D Message
When no operation is performed for 5 sec. in initial set mode,
a message scrolls across the function display prompting you
for input.
Q
Message example
for microphone simple mode
28
D Mic simple mode
POWER ON
AT
This item turns the microphone simple
mode on or off. Microphone simple
mode is used to change the function
assignments for switches on the op-
tional HM-75A
CROPHONE
is convenient for 3-channel use of
simple operation.
Freq.
indication indication
[CALL] NULL
[V/m]
[UP]
[DOWN] [DOWN] [DOWN] MCH02 MCH02 MCH02
*Functions only when in conversation mode.
NOTE:
Turn power off when connecting the HM-75A to the trans-
ceiver.
VFO mode cannot be selected via the microphone when
SIMPLE mode is selected.
(Optional HM-75A required)
REMOTE CONTROL MI
as below. This assignment
NORMAL SIMPLE
CH Freq.
ANI
indication indication
NULL [ ]
NULL NULL [CALL] NULL
[UP] [UP] MCH01 MCH01 MCH01
-
HM-75A
CH
ANI
SWITCH
[ ] [ ]*
A
B
NULL