I Operation - Icom IC-T2H Instruction Manual

11
ANI OPERATION

I Operation

D Calling a specific station
➀
Turn power on and set the [VOL] control to the 10 or 12 o'-
clock position.
➁
Push the [Y]/[Z] keys to set the desired channel.
• " " appears when the ANI function has been programmed via
cloning.
➂
Push [PTT] once to connect to the selected station or enter
a 3-digit ANI code, if required (in this case it is not neces-
sary to push [PTT]—transmit is automatic after entry of the
3rd digit).
• The transceiver transmits the pre-programmed selective code.
➃
When the transceiver rings (an answer back is received),
wait for a connection code from the connected station;
when the transceiver doesn't ring, push [PTT] again to exit
the standby condition, then try again from step ➂ after wait-
ing awhile.
➄
When the connection code is received, a beep sounds,
then " " flashes; when the connection code is not re-
ceived within 10 sec., the transceiver transmits a discon-
nect code automatically ("
from step ➂ after waiting awhile , in such a case.
➅
When " " flashes, you can converse with the connected
station.
• Push to transmit; release to receive.
➆
When your conversation is finished, transmit the discon-
34
" does not flash). Try again
nect code.
• While pushing [PTT], push [#].
• Some transceivers cannot transmit a disconnect code depend-
ing on programming.
NOTE: When your conversation extends into the ANI time-
out time, the transceiver transmits a disconnect code au-
tomatically.
Try again after a while
Transmit
a selective code
Receive an
No Push [PTT] to
answer back
exit standby
code
Transmit
Receive
No
disconnect code
a connection
automatically
code
Yes
Converse
Transmit a
disconnect code
manually