Cleaning Evaporation Pan; Removing Scratches From Bumper - Hussmann MicroSC ISMGG2DA-A Installation & Operation Manual

P/N 3110586_A

CLEANING EVAPORATION PAN

The condensate water outlet for self contained
models empties into a limited capacity
evaporation pan.
Debris or dirt accumulation inside the condensate
evaporation pan will reduce the pan's
evaporation capacity and cause premature
heater failure. The evaporation pan waste water
will overflow and spill onto the floor if the heater
is not properly operating.
Remove accumulated debris from the evaporation
pan. Wipe down heater coil with a cloth and
warm water. Be sure to remove any dirt,
debris or liquids from the heater coil. Water
introduced during cleaning will cause the
evaporation pan to overflow.
REMOVING SCRATCHES FROM
BUMPER
Most scratches and dings can be removed
using the following procedure.
1. Use steel wool to smooth out the surface
area of the bumper.
2. Clean area.
3. Apply vinyl or car wax and polish surface
for a smooth glossy finish.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
DO NOT FLOOD!
Use only enough water necessary to clean
surface. Water must not drip down the case!
Never use ammonia based cleansers, abrasive
cleansers, or scouring pads.
ISMGG2DAA Merchandisers
4-3