Cisco Network Analysis Module 6000 Installation And Configuration Manual page 41

Upgrading the NAM Software
You can upgrade both the application software and the maintenance software. To upgrade the application
software, see the
maintenance software, see the
Upgrading the NAM Application Software
To upgrade the NAM application software, follow these steps:
Copy the NAM application software image to a directory accessible to FTP.
Step 1
Log in to the switch through the console port or through a Telnet session.
Step 2
To upgrade the application software, the NAM must be running in the maintenance image. If the NAM
Step 3
is already running in the maintenance image, go to
mode:
Router#hw-mod module 9 reset hdd:2
Device BOOT variable for reset = hdd:2
Warning:Device list is not verified.
Proceed with reload of module? [confirm]
% reset issued for module 9
Router#
00:03:31:%SNMP-5-MODULETRAP:Module 9 [Down] Trap
00:03:31:SP:The PC in slot 9 is shutting down. Please wait ...
00:03:41:%SNMP-5-COLDSTART:SNMP agent on host R1 is undergoing a cold
start
00:03:46:SP:PC shutdown completed for module 9
00:03:46:%C6KPWR-SP-4-DISABLED:power to module in slot 9 set off (admin
request)
00:03:49:SP:Resetting module 9 ...
00:03:49:%C6KPWR-SP-4-ENABLED:power to module in slot 9 set on
00:05:53:%SNMP-5-MODULETRAP:Module 9 [Up] Trap
00:05:53:%DIAG-SP-6-BYPASS:Module 9:Online Diagnostics is Bypassed
00:05:53:%OIR-SP-6-INSCARD:Card inserted in slot 9, interfaces are now
online
Router#
After the NAM is back online, establish a console session with the NAM and log in to the root account.
Step 4
Router#session slot 9 proc 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.91 ... Open
Cisco Network Analysis Module (WS-X6380-NAM)
Maintenance Partition
login:root
Password:
Network Analysis Module (WS-X6380-NAM) Console, 1.2(1a)m
Copyright (c) 1999, 2000, 2001 by cisco Systems, Inc.
Upgrade the NAM application software by entering:
Step 5
root@localhost#upgrade ftp-url
ftp-url is the FTP location and name of the NAM software image file.
78-10406-05
"Upgrading the NAM Application Software" section on page
"Upgrading the NAM Maintenance Software" section on page
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
Step 4. Otherwise, enter this command in privileged
Administering the NAM
50. To upgrade the
51.
41