Cisco Network Analysis Module 6000 Installation And Configuration Manual page 31

sysDescr
sysObjectID
sysContact
sysName
sysLocation
root@localhost#
Operating System-Independent Configuration
The following sections describe the NAM configurations that are independent of the switch operating
system.
Configuring Automatic RMON Collections
Use the autostart command to specify that some collections should be automatically configured on
every available data source (including all known VLANs) whenever the NAM is initialized. These
collections may also be configured explicitly through SNMP by a management station on some data
sources. Collections that are explicitly configured through SNMP take precedence over "autostart"
collections, so if both are configured, only the explicitly configured collections are started on each data
source when the NAM initializes.
If you enter the command that instructs the NAM to automatically start a collection, you must reboot the
NAM for that command to take effect.
The NAM allows the following collection types to be started automatically:
•
•
•
•
•
For example, each dataSource (interface or VLAN) is configured with an etherStatsEntry (from
RMON-1) after you enter the autostart etherstats enable command and reboot the NAM. The
etherStatsOwner field is set to the value monitor.
The automatic start process is performed after setting up any collections that were explicitly created
through SNMP by a management station, and stored in the NVRAM in the NAM. Automatic start
collections are not configured on data sources that already have a collection of that type configured
through SNMP.
Enable the etherStat collection type by entering this command from the root account of the NAM:
root@localhost# autostart etherstat enable
Enable the addressMap collection type by entering this command from the root account of the NAM:
root@localhost# autostart addressmap enable
Enable the prioStats collection type by entering this command from the root account of the NAM:
root@localhost# autostart priostats enable
78-10406-05
"Catalyst 6000 Network Management Module (WS-X6380-NAM)"
1.3.6.1.4.1.9.5.1.3.1.1.2.223
"Jane Doe, Cisco Systems, (408) 111-1111"
"6k-NAM - Slot 2"
"Cisco Lab, Building X, Floor 1"
addressMap—addressMapTable from RMON2-MIB (RFC 2021)
If the NMS never sets the addressMapMaxDesiredEntries scalar, then the NAM uses the value -1
(for no limit).
art—artControlTable from draft-warth-rmon2-artmib-01.txt
etherStat—etherStatsTable from RMON-MIB (RFC 1757)
prioStats—smonPrioStatsControlTable from SMON-MIB (RFC 2613)
vlanStats—smonVlanStatsControlTable from SMON-MIB (RFC 2613)
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
Configuring the NAM
31