Administering The Nam - Cisco Network Analysis Module 6000 Installation And Configuration Manual

Administering the NAM

Administering the NAM
How you administer the NAM on your switch depends on whether you are using the Cisco IOS software
or the Catalyst OS software. There are also NAM administration tasks that are common to either switch
operating system.
The following sections describe how to administrate the NAM from the CLI for each switch operating
system:
•
•
When you have completed administrating the software-dependent attributes for the NAM, you can
configure the software-independent NAM attributes in this section:
•
These sections describe how to administer the NAM:
Cisco IOS Software
This section contains the various administrative tasks you can perform on the NAM with Cisco IOS:
•
•
•
•
Logging in to the NAM
The NAM has two user levels with different access privileges:
•
•
The root account uses the # prompt; the guest account uses the > prompt.
Note
To log in to the NAM, follow these steps:
Log in to the Catalyst 6000 family switch using the Telnet connection or the console port connection.
Step 1
At the CLI prompt, establish a console session with the NAM using the session slot slot_number
Step 2
processor processor_number command, as follows:
Router#session slot 8 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.81 ... Open
Cisco Network Analysis Module (WS-X6380-NAM)
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
38
Cisco IOS Software, page 38
Catalyst OS Software, page 46
Operating System-Independent Administration, page 53
Logging in to the NAM, page 38
Changing and Recovering the NAM CLI Passwords, page 48
Resetting the NAM, page 49
Upgrading the NAM Software, page 49
guest-Read-only access
The default password is "guest."
root-All read and write access
The default password is "root."
78-10406-05