Cisco Network Analysis Module 6000 Installation And Configuration Manual page 26

Configuring the NAM
Verify the SNMP access controls and settings by entering this command:
Step 17
root@localhost# show snmp
After completing this configuration, you can use the NAM with a network-monitoring application, such
as TrafficDirector or any other IETF-compliant RMON application.
If you are using TrafficDirector, you must enter the community strings in TrafficDirector exactly as
Note
you enter them in the NAM.
This example shows how to configure the NAM:
Console> (enable) session 2
Trying NAM-2...
Connected to NAM-2.
Escape character is '^]'.
Network Analysis Module (WS-X6380-NAM)
login: root
Password:
Network Analysis Module (WS-X6380-NAM) Console, 2.1(1a)
Copyright (C) 1999, 2000, 2001 Cisco Systems, Inc.
WARNING! Default password has not been changed!
root@localhost# ip address 172.20.52.29 255.255.255.224
root@localhost# ip broadcast 172.20.52.31
root@localhost# ip host nam1
root@localhost# ip gateway 172.69.2.132
root@localhost# ip domain cisco.com
root@localhost# ip nameserver 171.62.2.132
root@localhost# show ip
IP address:
Subnet mask:
IP Broadcast:
DNS Name:
Default Gateway:
Nameserver(s):
root@localhost#
root@localhost# snmp location "Cisco Lab, Building X, Floor 1"
root@localhost# snmp contact "Jane Doe, Cisco Systems, (408) 111-1111"
root@localhost# snmp name "6k-NAM - Slot 2"
root@localhost# snmp community public ro
root@localhost# snmp community private rw
root@localhost# show snmp
SNMP Agent:
SNMPv1:
SNMPv2C: Enabled
SNMPv3:
community public read
community private write
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
26
172.20.52.29
255.255.255.224
172.20.52.31
nam1.cisco.com
172.20.52.1
171.69.2.132
nam1.cisco.com 172.20.52.29
Enabled
Disabled
78-10406-05