Cisco Network Analysis Module 6000 Installation And Configuration Manual page 5

Table 1
Color
Orange
Off
SHUTDOWN Button
Caution Do not remove the NAM from the switch until the NAM has shut down completely and the STATUS
LED is orange. You can damage the NAM if you remove it from the switch before it completely shuts
down.
To avoid corrupting the NAM hard disk, you must correctly shut down the NAM before you remove it
from the chassis or disconnect the power. This shutdown procedure is normally initiated by commands
entered at the supervisor engine CLI prompt or the NAM CLI prompt.
If the NAM fails to respond to these commands properly, you must use the SHUTDOWN button on the
front panel to initiate the shutdown procedure.
To push the button, use a small pointed object (such as a paper clip).
The shutdown procedure may require several minutes. The STATUS LED turns off when the NAM shuts
down.
Hard Drive Activity LED
The hard drive (HD) activity LED is lit when the hard drive is in use.
PCMCIA Slot
The PCMCIA slot provides access for up to two standard PCMCIA cards (now known as PC cards) and
is reserved for future use.
78-10406-05
STATUS LED Description (continued)
Description
Indicates one of three conditions:
• The NAM is running through its boot and self-test diagnostic sequence.
The NAM is disabled.
•
• The NAM is in the shutdown state.
The NAM power is off.
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
Overview
5