Configuring Vlans; Using Netflow Data Export As A Traffic Source - Cisco Network Analysis Module 6000 Installation And Configuration Manual

sysDescr
sysObjectID
sysContact
sysName
sysLocation
root@localhost#

Configuring VLANs

You do not need to configure a VLAN as the NAM management port because that port automatically
synchronizes to the VLAN assigned to interface sc0 on the supervisor engine.
You cannot set the NAM management port VLAN with the set vlan mod/port command.
Note

Using NetFlow Data Export as a Traffic Source

To use NetFlow Data Export (NDE) as a traffic source for the NAM, you must enable the NetFlow
Monitor option to allow the NAM to receive the NDE stream. The statistics are presented on reserved
ifIndex.3000.
Configuration of the Multilayer Switch Function Card (MSFC) is necessary for using the NetFlow
Note
feature. For information on configuring NDE, refer to the Catalyst 6000 Family Software
Configuration Guide.
To enable the NetFlow Monitor option, perform these tasks:
Task
Step 1
Enable the NetFlow Monitor option.
Step 2 Verify that the NetFlow Monitor option is
enabled.
Step 3 Enable NDE.
This example shows how to enable the NetFlow Monitor option and verify that it is enabled:
Console> (enable) set snmp extendedrmon netflow enable 2
Snmp extended RMON netflow enabled
Console> (enable) show snmp
RMON: Enabled
Extended RMON Netflow Enabled : Module 2
Traps Enabled:
None
Port Traps Enabled: None
78-10406-05
"Catalyst 6000 Network Management Module (WS-X6380-NAM)"
1.3.6.1.4.1.9.5.1.3.1.1.2.223
"Jane Doe, Cisco Systems, (408) 111-1111"
"6k-NAM - Slot 2"
"Cisco Lab, Building X, Floor 1"
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
Command
set snmp extendedrmon netflow [enable |
disable] mod
show snmp
set mls nde enable
Configuring the NAM
27