Cisco Network Analysis Module 6000 Installation And Configuration Manual page 23

Cisco systems network analysis module installation and configuration guide

Hide thumbs Also See for Network Analysis Module 6000:

Installation manual (6 pages)

Table of Contents

Source VLANs:

RX Only:

TX Only:

Both:

Destination Ports:None

Filter VLANs:

Session 2

---------

Source Ports:

RX Only:

TX Only:

Both:

Source VLANs:

RX Only:

TX Only:

Both:

Destination Ports:None

Filter VLANs:

Router#conf t

Enter configuration commands, one per line.

Router(config)#monitor session 1 source vlan 1 both

The SPAN destination for the NAM must always be port 1.

Note

Router#

00:21:10:%SYS-5-CONFIG_I:Configured from console by console

Router#conf t

Enter configuration commands, one per line.

Router(config)#monitor session 1 destination interface gi 8/1

Router#show monitor

Session 1

---------

Source Ports:

RX Only:

TX Only:

Both:

Source VLANs:

RX Only:

TX Only:

Both:

Destination Ports:Gi8/1

Filter VLANs:

Session 2

---------

Source Ports:

RX Only:

TX Only:

Both:

Source VLANs:

RX Only:

TX Only:

Both:

Destination Ports:None

Filter VLANs:

Router#

78-10406-05

None

Catalyst 6000 Family Network Analysis Module Installation and Configuration Note

End with CNTL/Z.

Configuring the NAM

Table of Contents

Chapters

Table of Contents

Cisco Network Analysis Module 6000 Installation And Configuration Manual page 23

Chapters

Related Manuals for Cisco Network Analysis Module 6000

Related Products for Cisco Network Analysis Module 6000

Table of Contents