Maintaining And Administering The Rsfc - Cisco Catalyst 5000 Series Installation And Configuration Note

Maintaining and Administering the RSFC

This example shows how to configure an interface as part of HSRP group 100:
Maintaining and Administering the RSFC
These sections describe common maintenance and administrative tasks you need to perform on the
RSFC:
•
•
•
•
•
•
•
•
Setting the RSFC Module and Port Name from the Switch CLI
To set the name of the RSFC module and port from the switch CLI, perform this task in privileged
mode:
Task
Step 1
Step 2
Step 3
This example shows how to set the port name of the RSFC in slot 1 and verify the configuration:
18 Catalyst 5000 Series Route Switch Feature Card Installation and Configuration Note
Router#configure terminal
Enter configuration commands, one per line.
Router(config)#interface vlan100
Router(config-if)#standby 100 ip 172.20.100.10
Router(config-if)#standby 100 priority 110
Router(config-if)#standby 100 preempt
Router(config-if)#standby 100 timers 5 15
Router(config-if)#standby 100 authentication Secret
Router(config-if)#^Z
Router#
Setting the RSFC Module and Port Name from the Switch CLI, page 18
Downloading a System Image to the RSFC Flash, page 19
Downloading a System Image to the RSFC from the Switch CLI, page 19
Resetting the RSFC from the Switch CLI, page 20
Setting the Configuration Register Boot Field, page 20
Setting the BOOTLDR Variable, page 21
Setting the BOOT Variable, page 21
Assigning a Nondefault MAC Address to an Interface, page 22
Set the RSFC module name.
Set the RSFC port name.
Verify the configuration.
Console> (enable) set module name 15 RSFC module
Module name set.
Console> (enable) set port name 15/1 RSFC Port
Port 15/1 name set.
Console> (enable) show module 15
Mod Slot Ports Module-Type
--- ---- ----- ------------------------- ------------------- --------
15 1 1 Route Switch Feature Card WS-F5541
Mod Module-Name
--- ------------------- --------------------
15 RSFC module
End with CNTL/Z.
Command
set module name mod_num name_string
set port name mod_num/port_num name_string
show module [mod_num]
show port [mod_num[/port_num]]
Model
Serial-Num
00000001234
Status
ok