Configuring Vlans - Cisco HWIC-4ESW User Manual

How to Configure EtherSwitch HWICs

Configuring VLANs

This section describes how to configure VLANs on the switch and contains the following sections:
•
•
Adding a VLAN Instance
A total of 15 VLANs can be supported by an EtherSwitch HWIC.
Follow the steps below to configure a Fast Ethernet interface as Layer 2 access.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
vlan database
Example:
Router# vlan database
Step 3
vlan vlan_id
Example:
Router(vlan)# vlan 1
Step 4
exit
Example:
Router(vlan)# exit
Verifying the VLAN Configuration
You can verify the VLAN configuration in VLAN database mode.
Use the show command in VLAN database mode to verify the VLAN configuration, as shown below:
Router(vlan)# show
VLAN ISL Id: 1
Name: default
Book Title
6
Adding a VLAN Instance, page 6
Deleting a VLAN Instance from the Database, page 8
enable
vlan database
vlan vlan_id
exit
Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters VLAN configuration mode.
Adds an Ethernet VLAN.
Updates the VLAN database, propagates it throughout the
administrative domain, and returns to privileged EXEC mode.