Connector Specifications; Sfp Module Connectors - Cisco ME 3400E Hardware Installation Manual

Cisco systems ethernet access switch installation guide
Hide thumbs Also See for Cisco ME 3400E:
Table of Contents

Advertisement

Connector Specifications

When connecting 10/100 ports to compatible devices such as servers, workstations, and routers, you can
use a two or four twisted-pair straight-through cable wired for 10BASE-T and 100BASE-TX.
shows the two twisted-pair straight-through cable schematics.
straight-through cable schematics.
When connecting the ports to other devices, such as switches or repeaters, you can use a two or four
twisted-pair crossover cable.
Figure B-9
You can use the mdix auto interface configuration command in the CLI to enable the automatic
Note
medium-dependent interface crossover (auto-MDIX) feature. When the auto-MDIX feature is enabled,
the switch detects the required cable type for copper Ethernet connections and configures the interfaces
accordingly. Therefore, you can use either a crossover or a straight-through cable for connections to a
copper 10/100, 10/100/1000, or 1000BASE-T SFP module port on the switch, regardless of the type of
device on the other end of the connection.
You can use Category 3, 4, or 5 cabling when connecting to 10BASE-T-compatible devices. You must
use Category 5 (or higher) cabling when connecting to 100BASE-TX-compatible devices.
Use a straight-through cable to connect two ports only when one port is designated with an X. Use a
Note
crossover cable to connect two ports when both ports are designated with an X or when both ports do
not have an X.
This applies only to switches on which auto-MDIX is disabled.

SFP Module Connectors

Figure B-2
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
B-2
Figure B-7
shows the four twisted-pair crossover cable schematics.
Fiber-Optic SFP Module LC Connector
Appendix B
Figure B-8
shows the two twisted-pair crossover cable schematics.
Connector and Cable Specifications
Figure B-6
shows the four twisted-pair
OL-16447-01

Advertisement

Table of Contents
loading

Table of Contents