Preparing For Installation; Grounding The Switch - Cisco ME 3400E Hardware Installation Manual

Cisco systems ethernet access switch installation guide
Hide thumbs Also See for Cisco ME 3400E:
Table of Contents

Advertisement

Chapter 3
Installing and Removing AC- and DC-Power-Supply Modules
Each DC-power input (A ± and B ±) is connected to both power-supply module 1 (PSU 1) and
power-supply module 2 (PSU 2). The power-supply modules cannot be powered independently.
DC inputs and returns are diode-isolated
Figure 3-9
DC A
DC B

Preparing for Installation

Obtain these necessary tools and equipment:
To order a spare or replacement DC-connector, use this source:

Grounding the Switch

To make sure that the equipment is reliably connected to earth ground, follow the grounding procedure
instructions and observe these warnings:
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
OL-16447-01
DC-Power-Supply Diagram
PSU-1
PSU-2
Ratcheting torque screwdriver with a number-2 and a number-1 Phillips head that exerts up to
15 inch-pounds (in-lb).
Panduit crimping tool with optional controlled-cycle mechanism (model CT-720, CT-920,
CT-920CH, CT-930, or CT-940CH).
Wire-stripping tools.
Copper ground wire (insulated or noninsulated) for the ground connection.
Dual-hole, right-angle ground lug from the switch accessory kit (for the Cisco ME 3400E-24TS-M
and the Cisco ME 3400EG-12CS-M).
Dual-hole ground lug from the switch accessory kit (for the Cisco ME 3400EG-2CS-A).
Four leads of 16-gauge copper wire.
Four-position DC-terminal-block connector from the accessory kit.
Amphenol PCD: ELFF0422S1 (Cisco part number 29-6063-0).
http://www.amphenolpcd.com/
(Figure
3-9).
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
Power-Supply Module Installation
3-9

Advertisement

Table of Contents
loading

Table of Contents