Cisco ME 3400E Hardware Installation Manual page 94

Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
end
These choices appear:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by
selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default configuration that you created. If
you want to change this configuration or want to perform other management tasks, use the CLI.
To use the CLI, enter commands at the Switch> prompt through the console.
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
C-4
OL-16447-01