10.3.5 OUTDOOR UNIT ELECTRICAL
WIRING
TOP PREVIOUS NEXT
1. Remove Top Panel.
2. Remove Control Board Cover.
3. Remove Plugs.
4. Fix the conduit connector to the conduit hole with lock-nut, then secure it.
5. Connecting wire between indoor unit and outdoor unit should be UL listed or CSA approved 6
× AWG16 wire.
6. Secure the wire onto the control board with the holder (clamper).
7. Wire connection to the power supply (208/230V 60 Hz) through circuit breaker.
Connect the UL listed or CSA approved wires (AWG12) to the terminal board, and
connect the other end of the wires to circuit breaker.