Panasonic CS-A18CKPG Service Manual page 104

Remote Control Reset
●
When the batteries are inserted for the first time, or the batteries are replaced, all the
indications will blink and the remote control might not work.
If this happen, remove the cover of the remote control and you will find a resetting terminal,
and by shorting it with a minus screwdriver, it will return to normal.
Changing the wireless remote control transmission code
●
When two indoor units are installed in the same room, in order to prevent operating errors
caused by using two remote controls, cut a jumper wire at the remote control printed circuit
board (J - A) and cut a jumper wire at the indoor printed circuitboard (JX4). It is possible to
select from 4 types of transmission codes including one at time of delivery condition (0).
Fig. 9
Fig. 10