Panasonic CS-A18CKPG Service Manual page 71

The below operations will be performed by pressing the AUTO switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING PURPOSE)
The Test Run operation will be activated if the Auto Switch is pressed continuously for more
than 5 sec. to below 10 sec.. A pep sound will occur at the fifth sec., in order to identify the
starting of Test Run operation
3. REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote Controller receiving sound can be change over by pressing the AUTO
Switch continuously for 10 sec. and above. A pep, pep sound will occur at the tenth sec.,in
order to indicate the ON/OFF change over of remote control receiving sound.
TOP PREVIOUS NEXT
AUTO SWITCH OPERATION