Mounting / Installing / Connecting; Safety Measures During Assembly - Siemens VersiCharge 8EM1390 A0 Series Installation Instructions Manual

Mounting / Installing / Connecting

4.1

Safety measures during assembly

General information
Charging of electric cars must guarantee high electrical performance over long periods. The
pre-installation of the power supply and the installation of the Wallbox must comply with the
power requirements. To ensure that these requirements are fulfilled correctly, these
installation instructions are intended for qualified and trained electricians. As a qualified
electrician, you are responsible for safety, not only during installation, but also during
subsequent use by the operator and the end user.
To this end, follow The five safety rules for electrical work (Page 12).
Mount the Wallbox on a load-bearing wall or on the column provided.
Route the cables from below to the Wallbox.
Ensure that no loose parts fall or tip over during installation. Secure the door against falling.
Eliminate tripping hazards.
Risk of electric shock due to exposed electrical connections and components
Before starting the installation work, check that the supply cable has been disconnected
from the mains and secured against restart.
Do not connect the Wallbox if damage or tampering is visible.
Follow all safety instructions. This will help you avoid hazardous situations that could result
in serious injury or death.
Comply with all national requirements for testing the installation. Only qualified personnel
may mount the Wallbox. The following points describe the step-by-step mounting of the
Wallbox. Additional steps may be necessary at your location of use. These assembly instruc­
tions therefore do not claim to be exhaustive.
VersiCharge Column Mounting
Hardware Installation Manual, 06/2022, A5E51460654-AB
DANGER
WARNING
4
19