Battery Packs; Operating Procedure - Stanley Avdel NeoBolt PB2500N Instruction And Service Manual

3.6 BATTERY PACKS

NOTE: For best results, make sure your battery pack is fully charged.
3.6.1 INSTALLING and Removing the Battery Pack (Fig. 8b)
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
• Align the battery pack (M) with the rails inside the tool's handle (Fig. 8b) and slide it into the handle until
the battery pack is firmly seated in the tool and ensure that it does not disengage.
TO REMOVE THE BATTERY PACK FROM TO THE TOOL
• Press battery release button and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section for this manual.
STORAGE RECOMMENDATIONS
• The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. For
optimum battery performance and life, store battery packs at room temperature when not in use.
• For long storage, it is recommended to store a fully charged battery pack in a cool, dry place out of the
charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be
recharged before use.
3.6.2 FUEL GAUGE BATTERY PACKS
Some D WALT battery packs include a fuel gauge which
e
consists of three green LED lights that indicate the
level of charge remaining in the battery pack. The fuel
gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following
indicators:
To actuate the fuel gauge, press and hold the fuel gauge
button. A combination of the three green LED lights will
illuminate designating the level of charge left. When the
level of charge in the battery is below the usable limit,
the fuel gauge will not illuminate and the battery will
need to be recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application. For more information regarding fuel gauge
battery packs, please contact call 1-800-4-D
800-433-9258) or visit our website www.D

4. OPERATING PROCEDURE

WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery
pack before making any adjustments or removing/installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position.
WALT (1-
e
WALT.com.
e
E N G L I S H
75–100% charged
51–74% charged
< 50% charged
Pack needs to be
charged
15