Two-Post Rack Installation - Cisco Router ASR 1006 Hardware Installation Manual

Align the mounting bracket holes with the rack post holes and attach the chassis to the rack. At this point, if there is a
Step 7
third person, then that person can insert the screws while the other two people hold that chassis in place, unless the
chassis is resting on a shelf).
Position the chassis until the rack-mounting ears are flush against the mounting rails on the rack.
Step 8
Hold the chassis in position against the mounting rails and follow these steps:
Step 9
a. Insert the bottom screw into the third hole up from the bottom of the rack mount ear and use a hand-held screwdriver
to tighten the screw to the rack rail.
b. Insert the top screw into the third hole down from the top of the rack-mount bracket ear and tighten the screw to the
rack rail.
c. Insert a screw in the middle of the rack-mount bracket on both sides of the chassis. See
the other side of the chassis.
As a result of using the specified rack-mount bracket ear holes, the cable-management bracket can be easily
Note
attached to the rack-mount bracket when the chassis is in the rack.
This completes the procedure for installing the chassis in the four-post rack. Proceed to the
Bracket" section on page 9

Two-Post Rack Installation

TInner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26 cm). The
Note
height of the chassis is 1.73 inches (4.39 cm). Airflow through the chassis is from front to back.
Figure 5 Installing the Cisco ASR 1006 Router in a Two-Post Rack
2
2
1
1
0
0
F1
F0
R1
R1
R0
R0
8
to continue the installation.
ASR 1000 -SIP1
0
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS
PWR STATU
S
ASR 1000 -SIP1
0
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS
PWR STATU
S
ASR 1000 -SIP1
0
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS
PWR
ACTV
PWR STATU
S
STAT
STBY
ASR1 000-E SP10
PWR
ACTV
STAT
STBY
ASR1 000-E SP10
CRIT
PWR
ACTV
MAJ
STAT HD
STBY
MIN
ASR 1000 -RP1 USB
BF
0
1
DISK
CRIT
PWR CARR IER
ACTV
MAJ LINK
STAT HD
STBY BITS
MIN
ASR 1000 -RP1 USB MGMT ETHER
NET
CON
BF
AUX
0
1 DISK
CARR IER
LINK
BITS
MGMT ETHER
NET
CON
AUX
Ci sc o AS R
10 06
SPA-4 XOC3
-POS
SPA-4 XOC3 2
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
1
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
-POS 0
F1
F0
R1
R0
2 1
Figure 4. Repeat these steps for
"Attach the Cable-Management