Cisco Router ASR 1006 Hardware Installation Manual page 42

Figure 21 Handling a SPA
GND
To install a shared port adapter into a SPA interface processor (SIP), follow these steps:
Step 1 Before you begin, make certain the chassis is grounded.
To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and
Step 2
top right of the SPA slot and are recessed about an inch.
Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully
Step 3
seated, the SPA might be slightly behind the SIP faceplate. See
Figure 22 Installing and Removing a SPA Into and From a SIP
42
Printed circuit board
Metal carrier
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
SPA -4X OC
3-P OS
Figure
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
22.