17 ENGINE
17.4.13
196
Changing the connecting rod, conrod bearing, and crank pin
310046-10
310071-10
Info
After replacing the crankshaft bearings, the crankshaft
end play must be measured.
Finishing work
-
Measure the crankshaft end play.
Main work
-
Position the crankshaft with special tool
I Separator plate (79429009000)
-
Press the crank pin out of the upper crankweb with special
tool@.
I Crankshaft pressing tool (75029047000)
•
Info
I
Hold the lower crankweb.
-
Remove the connecting rod and bearing.
fD
-
Press crank pin
out of the lower crankweb.
-
Place the crankweb onto special tool
Insert for crankshaft pressing tool (79429008000)
(!l
p. 315)
Info
The special tool must be positioned with the flat sur
face facing downward.
0
-
Press in new crank pin
6)
✓ Oil channel
is aligned with oil channel Cs).
X If the oil channels are not correctly aligned, the conrod
bearing will not be supplied with oil.
-
Blow compressed air through the oil channels to check that
they are clear.
(!l
p. 198)
O
in the press.
p. 315)
(!l
(!l
p. 311)
C,.
all the way.