Table of Contents
Advertisement
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
-4!)
-
Move the brake reservoir mounted on the handlebar to a hori-
zontal position.
-
Cover painted parts.
O.
-
Remove screws
-
Take off cover@ with the membrane.
-
Extract the old brake fluid from the brake fluid reservoir using
a syringe and fill with fresh brake fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1
8.
-
Mount bleeder cover
I
Bleeder cover (00029013002)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
8.
-
Open shut-off valve
Info
•
I
Follow the instructions in the Owner's Manual of the
bleeding device.
-
Ensure that the inflation pressure is set on pressure
gauge 6). Correct the inflation pressure on pressure
0
regulator
if necessary.
I
Guideline
Inflation pressure
0
-
Pull off protection cap
bleeder bottle hose.
I
Bleeding device (00029013100)
(D
-
Open bleeder screw
Info
Drain until fresh brake fluid emerges in the bleeder
bottle hose without bubbles.
-
Tighten the bleeder screw.
8.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
BRAKE SYSTEM 16
(0
p. 306)
(0
p. 300)
(0
p. 304)
(0
p. 304)
1
2 ... 2.5 bar (29 ... 36 psi)
of the bleeder screw. Connect the
(0
p. 304)
by approx. one half turn.
149
Advertisement
Table of Contents
