Removing and Replacing the RP
Figure 7-15
a
b
c
Installing the RP
As noted in the preceding section, Figure 7-15 illustrates an RP being removed from a
Cisco 12012. For purposes of the RP installation procedure presented in this section, it is
assumed that you will be performing the reverse of the procedure illustrated in Figure 7-15,
but in the context of the Cisco 12008. It is also assumed that you will be installing the RP
in slot 0 of the upper card cage of the Cisco 12008.
7-54
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
Removing the RP (Cisco 12012 Shown)
Loosen
captive
screws
Pivot ejector
levers away
from card to
unseat card
GRP
Grasp card carrier to
slide card out of slot