Adding A Dc-Input Power Supply - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Adding, Removing, or Replacing a DC-Input Power Supply
To add, remove, or replace a DC-input power supply, you need the following tools:
•
A 1/4-inch flat-blade screwdriver (to loosen/tighten the captive installation screw on the
power supply faceplate).
•
A 10 mm, hollow-shaft nutdriver (to secure the source DC power cables to the terminals
on the power supply with the lock washers and nuts). A 1/4-inch socket wrench with a
10 mm deep-well socket will also suffice for this purpose.
•
A voltmeter (to test the voltages across the source DC power cables).
The replacement DC-input power supply (product number PWR-GSR8-DC=) is the only
part that you will need during the following procedures.
Caution
same chassis.

Adding a DC-Input Power Supply

In the following procedure, it is assumed that you will be adding a second DC-input power
supply to the router. It is also assumed that a blank filler panel is installed in the vacant
power supply bay.
Note
ensure EMI compliance and the proper flow of cooling air through the router.
Warning
a second, independent DC power source available to service the unit.
7-18
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
You cannot use an AC-input power supply and a DC-input power supply in the
A vacant power supply bay must always be covered with a blank filler panel to
Before attempting to install a redundant DC-input power supply, you must have