Configuring the Cisco 12008
Interface
IP-Address
Ethernet0
unassigned
POS3/0
unassigned
POS3/1
unassigned
POS3/2
unassigned
POS3/3
unassigned
ATM4/0
unassigned
.
.
.
Interface
IP-Address
Ethernet0
3.3.1.1
POS3/0
2.1.1.1
POS3/1
2.1.1.2
POS3/2
2.1.1.3
POS3/3
2.1.1.4
ATM4/0
1.1.1.2
.
.
.
Step 4
4-16
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
Pressing Return in either case accepts the default response [yes].
The following sample display results from a yes response to the current interface
summary query that is entered while you are using the setup facility. The display
shows that no interfaces have been configured:
OK? Method Status
YES unset
administratively down down
YES unset
administratively down down
YES unset
administratively down down
YES unset
administratively down down
YES unset
administratively down down
YES unset
administratively down down
The following sample display results from a yes response to the current interface
summary query that is entered while you are using the setup command. The
display shows that some interfaces have already been configured.
OK? Method Status
YES NVRAM
up
YES NVRAM
up
YES NVRAM
up
YES NVRAM
up
YES NVRAM
up
YES NVRAM
up
Select the protocols that you intend to support for your network interfaces.
For IP–only installations, you can accept the default values for most of the
questions.
Protocol
Protocol
up
up
up
up
up
up