Sample Display Of Global Parameters - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Step 10
On completion of this procedure, you have successfully established the router's global
configuration parameters.

Sample Display of Global Parameters

The following sample display lists the global parameters that you entered in Step 3 through
Step 10 in the preceding section.
Note SNMP is the most widely supported standard for managing networks.
SNMP provides a means to access and set configuration and run-time
parameters and to monitor and control network elements for routers and
communication servers. For more information about SNMP, refer to the
appropriate software configuration publications listed in the section entitled "If
You Need More Configuration Information."
Enter yes or no to the following query to accept or refuse Connectionless
Network Service (CLNS) management:
Configure CLNS? [no]: yes
CLNS router tag [area_1]:
CLNS domain [49]:
CLNS area [0001]:
CLNS station id [0027.25E9.B640]:
Note CLNS is an Open System Interconnection (OSI) layer service that does
not require a circuit to be established before transmitting data. For more
complete information about CLNS, refer to the appropriate software
configuration publications listed in the section entitled "If You Need More
Configuration Information."
Observing System Startup and Performing a Basic Configuration 4-19
Configuring the Cisco 12008