Cisco Gigabit Switch Router 12008 Installation And Configuration Manual page 278

Loading and Running Diagnostics
FD 2> ****************************************************
FD 2> GSR Field Diagnostics V3.0
FD 2> Compiled by award on Tue Aug 3 15:58:13 PDT 2000
FD 2> view: award-bfr_112.FieldDiagRelease
FD 2> ****************************************************
FD 2> BFR_CARD_TYPE_OC48_1P_POS_TTM testing...
FD 2> running in slot 2 (73 tests)
Executing all diagnostic tests in slot 2
(total/indiv. timeout set to 600/220 sec.)
FD 2> Verbosity now (0x00000001) TESTSDISP
FDIAG_STAT_IN_PROGRESS: test #1 R5K Internal Cache
FDIAG_STAT_IN_PROGRESS: test #2 Burst Operations
FDIAG_STAT_IN_PROGRESS: test #3 Subblock Ordering
FDIAG_STAT_IN_PROGRESS: test #4 Dram Marching Pattern
FDIAG_STAT_IN_PROGRESS: test #5 Dram Datapins
FDIAG_STAT_IN_PROGRESS: test #6 Dram Busfloat
.
.
.
FDIAG_STAT_IN_PROGRESS: test #73 SDRAM Traffic
FDIAG_STAT_DONE
Field Diagnostic ****PASSED**** for slot 2
Field Diag eeprom values: run 0 fail mode 0 (PASS) slot 2
Shutting down diags in slot 2
Board will reload
SLOT 2:%SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-MZ), Released Version 12.0(n)GS
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Fri 17-Sep-00 17:58 by ...
Router#
When you set the verbose option, most of the information returned by the diagnostic tests
is status messages that indicate when tests start and when they are completed. At the end of
the diagnostic tests, a message indicates whether the card passed or failed the tests.
6-8 Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
last test failed was 0, error code 0