Removing An Ac-Input Power Supply - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Figure 7-4
a Connect
power cord

Removing an AC-Input Power Supply

For the following procedure, it is assumed that you will remove an AC-input power supply
from a Cisco 12008 that is equipped with a single such unit. In this case, you must power
down the router before removing the power supply.
Adding, Removing, or Replacing an AC-Input Power Supply
Connecting Power to an AC-Input Power Supply
0
INPUT
0K
OUTP UT
FAIL
b Attach bail latch
Maintaining the Cisco 12008 7-11
c Connect
power cord