ECS P6VAP-Me Manual page 63

Video Off Method
This item defines how the video is powered down to save power. As a default,
this is set to DPMS (display power management software).
MODEM Use IRQ
If you want an incoming call on a modem to automatically resume the system
from a power-saving mode, use this item to specify the interrupt request line
(IRQ) that is used by the modem. You might have to connect the fax/modem to a
mainboard Wake On Modem connector for this feature to work.
Soft-Off by PWRBTN
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can be
resumed by Wake Up Alarms. This item lets you install a software power down
that is controlled by the normal power button on your system. If the item is set to
Instant-Off, then the power button causes a software power down. If the item is
set to Delay 4 Sec. Then you have to hold the power button down for four
seconds to cause a software power down.
Wake Up Events
Press Enter to display the Wake-Up Events sub-menu.
VGA
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the video graphics system.
LPT & COM
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the serial ports,or the parallel port.
60
Default: DPMS Support
Default: 3
Default: Instant-Off
Default: OFF
Default: LPT/COM