ECS P6VAP-Me Manual page 52

IDE HDD Auto-Detection
Press Enter while this item is highlighted if you want the setup utility to
automatically detect and configure a hard disk drive on the IDE channel.
IDE Primary/Secondary Master/Slave
If you leave this item at Auto, the system will automatically detect and configure
any IDE devices it finds. If it fails to find a hard disk, change the value to Manual
and then manually configure the drive be entering the characteristics of the drive
in the items below (Capacity, Cylinder, Head, Precomp, etc.), If you have no
device installed change the value to None.
Access Mode
This items defines some special ways that can be used to access IDE hard disks
such as LBA (Large Block Addressing). Leave this value at Auto and the system
will automatically decide the fastest way to access the hard disk drive.
Press Esc to close the IDE device sub-menu and return to the Standard CMOS
Features page.
Drive A and Drive B
These items define the characteristics of any diskette drive attached to the
system. You can connect one or two diskette drives.
Floppy 3 Mode Support
Floppy 3 mode refers to a 3.5" diskette with a capacity of 1.2 MB. Floppy 3 mode
is sometimes used in Japan.
Video
This item defines the video mode of the system. This mainboard has a built-in
VGA graphics system so you must leave this item at the default value.
Default: 1.44M, 3.5 in., None
Default: Disabled
Default: EGA/VGA
49