Installing A Socket-370 Processor - ECS P6VAP-Me Manual

Installing a Socket-370 Processor

If you have decided to install the mainboard with a FC-PGA Celeron
processor, follow the steps below.
Locate the Socket-370 and CPUFAN1
1. On the mainboard, locate the socket-370 and CPUFAN1.
2. On the socket-370, pull the locking lever away from the socket to
unhook it and then raise the locking lever to the upright position.
3. Identify the pin-1 corner on the socket-370 and the pin-1 corner on
the processor. The socket pin-1 corner is adjacent to the handle of
the locking lever. The processor pin-1 corner is beveled.
4. Matching the pin-1 corners, drop the processor into the socket. No
force is required and the processor should seat into the socket
easily.
5. Swing the locking lever down and hook it under the latch on the
edge of the socket. This locks the processor in place.
6. Locate the power cable on the heatsink/cooling fan assembly that is
attached to the top of the processor.
7. Plug the power cable into the CPUFAN1 power supply on the
mainboard.
29