Adjusting The Headlight Beams - Yamaha RS Venture RST9NJ Owner's Manual

1. Weatherstrip
11. Install the headlight unit bolts and wind-
shield stay bolts, and then tighten them
to their specified torques.
Tightening torques:
Headlight unit bolt:
3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
Windshield stay bolt:
14 N·m (1.4 kgf·m, 10 lb·ft)
12. Install the top cover and the shroud.
ESU14151

Adjusting the headlight beams

RST1NTF / RST1NTFY
1. Remove the top cover. (See page 59 for
removal procedures.)
2. Use a Phillips screwdriver to turn the
headlight beam adjusting screw and ad-
just the headlight beams. To lower the
headlight beams, turn the headlight
beam adjusting screw in direction (a). To
raise the headlight beams, turn the head-
light beam adjusting screw in direction
(b).
Periodic maintenance and adjustment
1
(b)
1
1. Headlight beam adjusting screw
3. Install the top cover.
RST9N
1. Open the shroud.
2. Insert a Phillips screwdriver into the hole
under the shroud to turn the headlight
beam adjusting screw. To lower the
headlight beams, turn the Phillips screw-
driver in direction (a). To raise the head-
light beams, turn the Phillips screwdriver
in direction (b).
1. Headlight beam adjusting screw
(a)
95